Suspension and Opaque Sample Measurement

The measurement of suspension samples is difficult due to the scattering of reflected light by fine particles in solution. This prevents 100% of the light from reaching the detector, making it more difficult for a clear spectrum to be obtained. Accessories used in this type of sample measurement are integrating spheres. As shown in the figure below, the integrating sphere method utilizes a barium sulfate-coated sphere to draw the scattered light inside so that all light reaches the detector.


ISR-240A Integrating Sphere Attachment

ISR-240A

  • Angle of incident light: 0°
  • Wavelength range: 240 to 800 nm
  • Maximum size of reflection sample:
    40 mm W x 70 mm H x 10 mm T or
    70 mm W x 70 mm H x 5 mm T
  • Cell holder for transmission sample:
    with holder for 10 mm square cell (excluding cell), 2 sample plates for BaSO4 standard white board, 2 plates for powder samples
  • For UV-2450/2550/3600

ISR-2200 Integrating Sphere Attachment

Diffuse and spectral reflection can be measured without using special attachments by combining a 0°/8° incident integrating sphere with the S/R exchange function of the spectrophotometer. Since the size of the flux of the reflection measuring unit can be altered, micro samples with a minimum flux size of 2 x 3 mm can be measured. The flux size of the transmission measuring unit also can be closed down to about 3 x 3 mm.
 

  • Angle of incident light: 0°/8°
  • Wavelength range: 220 to 850 nm
  • Maximum size of reflection sample:
    70 mm W x 70 mm H x 20 mm T (0° angle of incidence side)
    70 mm W x 70 mm H x 12 mm T (8° angle of incidence side)
  • Cell holder for transmission sample:
    with holder for 10 mm square cell (excluding cell), 2 sample plates for BaSO4 standard white board, 2 plates for powder samples
  • For UV-2450/2550/3600

ISR-3100 Integrating Sphere Attachment

  • Angle of incident light: 0°/8°
  • Wavelength range: 220 to 2600 nm
  • Maximum size of reflection sample:
    about 100 mm dia. x 15 mm T
  • Cell holder for transmission sample:
    with holder for 10 mm square cell (excluding cell), 2 sample plates for BaSO4 standard white board, 2 plates for powder samples
  • For UV-3600

ISR-2600/ISR-2600Plus Integrating Sphere Attachment

  • Angle of incident light: 0°/8°
  • Measurement wavelength range:
    ISR-2600 220 to 850 nm, ISR-2600Plus 220 to 1400nm
  • Maximum size of reflection sample:
    70 mm W x 70 mm H x 20 mm T (0° angle of incidence side)
    70 mm W x 70 mm H x 12 mm T (8° angle of incidence side)
  • For UV-2600



Note: ISR-2600 can be used with UV-2700.

This page may contain references to products that are not available in your country.
Please contact us to check the availability of these products in your country.

Top of This Page